Rapid Chill Operation Guide for Your Beverage Cooler
- Make sure the unit is unplugged. Lift the lid and add approximately 32-34 ice cubes (one to two standard ice trays of cubes) into the machine. Make sure ice is not trapped between the roller and the side ribs.
- Pour approximately two cups of water (16 oz.) into the ice-water bin. Check to see if the ice-water bath is above the minimum fill line, but not over the maximum fill line.
- Make sure the unit is on a clean, dry level surface and plug the electrical cord into an appropriate outlet. Lift the lid and place your beverage container HORIZONALLY onto the roller with the container neck facing out. For maximum cooling results, the container should be resting on the right hand side facing the unit.
- Close the lid and secure the front removeable lid. Check to make sure the lid is securely down to prevent water from leaking.
- If your container has a long neck, such as with a typical wine bottle, remove the front lid cap by sliding it downward. This allows the neck of the bottle to stick out of the unit.
- Choose the setting on the electronic touch pad timer to chill your desired beverage.
- Once the cycle setting is chosen, press the START/STOP button and watch your beverage chill to perfection. Though times are pre-set, the cycle can be stopped at any time by pressing the START/STOP button again.
- After the unit has cycled, make sure the motion has stopped. Lift the lid and remove your cold beverage and enjoy it!
- To continue chilling additional beverages, check to make sure the ADD ICE indicator light is off. If not, add more ice until it is off, as needed.
Remember, the Cooler Cooler ™ can rapidly chill room temperature beverages from 77°
F to 43°
F in as little as one minute. By pressing the extra button, one more minute gets you an ice-cold 34°
F drink!
|
